laser etching engraving
The laser marking machine produced by CKLASER can be used as mature marking equipment, the probability of its fault is generally very low, and the advantages of the laser marking machine include fast marking speed, fine line and good effect. It can be used in many products with higher marking requirements.
The laser marking machine is likely encounter some minor faults after used for a long period of time. TASTELASER will explain some minor faults that may occur to the fiber laser marking machine below. In order to make you judge and eliminate some simple faults in a timely manner, we have listed the fault phenomena that may easily occur and the solutions which can help solve the problems.
1、Fault: The power indicator light is not on; Failure reason: The power cable is not connected well, or the power indicator light is damaged.
Solution methods: Connect the power cable and replace the indicator light.
2、Fault: The laser indicator is lit up but there is no laser output; Failure reason: The field lens cover is not removed, and the set value of the power percentage is too low;
Solution methods: Remove the field lens cover and turn up the percentage of power.
3、Fault: The laser indicator is not on and there is no laser output; Failure reason: The signal connecting cable is not connected well;
Solution method: Reconnect the signal cable.
4、Fault: The laser indicator is not on but there is laser output; Failure reason: The laser indicator has broken down;
Solution method: Replace the laser indicator.
If the faults cannot be troubleshoot by the above methods, you can contact the after-sales customer service of CKLASER, all of the laser marking machines produced by TASTELASER have after-sales warranties, and they will troubleshoot the faults as quickly as possible.